Thread pre-coated adhesive for locking

2. Typical uses:

It can be applied to bolts and pipe joints.

3. State before curing:

4. Performance after curing:

(M10 steel nuts and bolts cured at 22℃ for 24 hours)

 5. Usage:

Clean the thread surface with JOM7755 cleaner and dry it.

Mixing: Add JOM204 activator (Component B) to JOM204 (Component A) at a ratio of 28:1, mixing thoroughly without excessive force to prevent disruption of the active ingredients, which could cause spontaneous curing or reduced locking performance.

Drying: the workpiece after glue coating is dried at 70-90℃ for 25-60 minutes, the time is extended or shortened appropriately according to the size of the workpiece.

Validity period: generally only for the same day. If not used up on the same day, it can be stored in cold storage. The adjusted glue should be used up within 5 days.

6. Storage conditions:

This product should be stored in a dry, cool and ventilated place.

To avoid contamination of unused adhesive, do not pour the adhesive back into the original packaging container.

Keep away from children.

explain

The data in this document was obtained under laboratory conditions. Due to variations in usage conditions, users should refer to these data and usage conditions for analysis and experimentation to obtain necessary advisory information. JOME Company does not guarantee the performance of JOME products under sales or specific operating conditions, nor does it assume any direct or indirect losses or liabilities arising therefrom.

If you encounter any issues during use, please contact JOMEi Company's Technical Service Department. We will provide you with full assistance.