Super glue

Product Description

JOM4860 is a single component, high

viscosity cyanoacrylate adhesive. No-odor and

non-blooming characteristics make this

product user friendly when vapor control is an issue.

Physical Properties Monomer (Liquid)

Base Compound          Ethyl Cyanoacrylate

Curing Properties

Ambient  surface  moisture  will  initiate  the hardening   process.   Handling    strength   is reached in a short period of time and varies depending on environmental conditions and substrates    being    bonded.    Product    will continue to cure for at least 24 hours before full strength and resistances are developed.

 Setting Time (68°F, 65% R.H.)

 Curing Performance

The gap of the bond line will affect set speed. Smaller  gaps  tend  to  increase  the  speed. Activators  can  be   applied  to   improve  set speed but may also impair overall adhesive performance.

 Performance of Cured Materials

Tensile Shear strength after 48 hours at 20° to 25°C

Substrate                    Range in N/mm2

Blasted Steel                         16 to 20

Etched Aluminum                 11 to 18

Neoprene                                > 10

ABS                                        > 6

Polycarbonate                          > 5

PVC                                        > 6

 Temperature Resistance

Sheer Strength on steel after 1 week at 22 °C

Chemical Resistance

Sheer strength on steel after 12 month soak   % Strength Retained

Solvent

Motor Oil                             100

Gasoline                               100

Tricloroethane                    100

Freon TA                              100

10% NaOH                          0

10% Hcl                               0

Water                                     0

General Instructions

Surfaces to be bonded should be clean and dry.Dispense a drop or drops to one surface only. Apply only enough to leave a thin film layer after compression.

Press parts together and hold firmly for a few seconds.   Good    contact   is    essential.   An adequate  bond  develops  in  less  that  one minute and maximum strength is attained in 24 hours.

Wipe off excess adhesive from the top of the container and recap. Cyanoacrylate products if    left    uncapped    may     deteriorate    by contamination from moisture in the air.

Because   Cyanoacrylate   products   cure   by polymerization, whitening may appear on the surface   of  the   container   or   the   bonded materials. Should this happen, wipe surfaces well with acetone.

For  safe   handling   information   on   this product, consult the Material Safety Data Sheet, (MSDS)

General Information

Storage

Refrigeration   at   40°F   provides   optimum storage stability.

Note

Prior to use, remove all surface contaminants such as oil or grease. Products like isopropyl alcohol  can  be  used.  Test  compatibility  of cleaner with substrate. Make sure surface is completely dry before bonding.

 Health & Safety in use

CAUTION: SuperGlues bond skin and eyes on contact. If accidental skin bonding occurs, wash area with warm soapy water and slowly pry skin apart using a blunt object (such as a teaspoon  handle.)  In  case  of  eye   contact, bathe   immediately   with   water   and   seek immediate medical attention.